Failed to initialize

Bazm · Post by **Bazm** » Mon Jan 16, 2006 11:07 pm

Good afternoons.

Excuse by being but I do not specify in my question of yesterday.
The questions are that when attempt to see a level that I finish creating and I click on the button view whit the engine appears to me message with the following text.

"Could not start the engine Driver or mode problem".

And

"Failed to initialize engine".

I have installed Directx 9.

Thanks.

Post by **AndyCR** » Tue Jan 17, 2006 1:14 am

what graphics card do you have?

Post by **QuestOfDreams** » Tue Jan 17, 2006 11:50 am

Don't use the "View with engine" button, use the "build *.bsp File" button and in the Compile Manager Dialog that will pop up, check "Preview in Reality Factory" then press OK

dodger · Post by **dodger** » Sat Sep 23, 2006 11:47 pm

Hi everyone,

I had the same problem as you Bazm
so i followed QuestOfDreams instructions
i can now load my level's o.k

what i would like to understand is why i got the
"Failed to initialize engine". error
is this down to my graphics card?.

specs ...
windows me
128 ram
intel(r) 82810 graphics controler
directx 9

Thank you for your help.

dodger.

GD1 · Post by **GD1** » Sun Sep 24, 2006 3:58 pm

you get the "failed to initialize" error because that button performs a command that was originally designed for Genesis3D WITHOUT RF.

Basically, the button doesn't work, we just haven't taken it out yet.

dodger · Post by **dodger** » Sun Sep 24, 2006 7:17 pm

Thank you for the info GD1

b.t.w nice website ... with good sounds.
will visit again ...
Dodger.

GD1 · Post by **GD1** » Mon Sep 25, 2006 1:48 am

dodger wrote:b.t.w nice website ... with good sounds.
will visit again ...
Dodger.

Thanks

we're not the best, but we try

Failed to initialize

Failed to initialize

re:re