Reality Factory

Hi there.

When I add water to my level and use the liquid entity, and then use the Tintcolor funktion to color the water, something annoying happends. I compile my level and the air also gets colored. It should only be the water that is colored, but all the air above the water is also colored. So when I walk around on the ground, it looks like I am diving in the water. Does anyone know how to fix this?

Thanks

Make sure the brush you are using for water is not overlapping any other brushes. In fact, keep your water brush one texel away from adjoining brushes. I had a whole room become water once because the engine got 'confused'.

See if that helps.

Ok, thanks for the answer

No problem. Be sure you keep us posted on your progress.

of course