Reality Factory

when i try to test my basic level (all it is is a box with a texture) it says "ERROR COMPILING LEVEL" what do i do so i can test me levels ??????????

you also need to add another two things within the single room, this tells the game about the player you are controling and where the player will start, these are called player setup and player sart, these are found in the left side under entities.

scott wrote:you also need to add another two things within the single room, this tells the game about the player you are controling and where the player will start, these are called player setup and player sart, these are found in the left side under entities.

and that is were if you dont mind can you put up a picture thanks IF you feel like it

Inside of RFEditPro, you'll find a tab that says TEMPLATES by the left edge of the screen. Select that tab, and you should see a bunch of shapes. Below those shapes, you'll see a drop-down menu. In that list you'll see the PLAYER SETUP and the PLAYER START entities. Place those in your level. They must be inside the walls of your level.

Other than that, you must make sure you have no leaks (holes) to the black void from within your level.

go over this site its where i learnt how to use RF all that time ago
http://www.jlstsi.com/genesis3d.htm
while the interface is not the same it uses exactly the same functions just look around until you find the button or menu it mentions