Brush==NULL

zany_001 · Post by **zany_001** » Wed Mar 28, 2007 2:59 am

if i type two small numbers for a brush size in,say,the y axis boxes,for a brush,then it says Brush==NULL,and then it closes.

darksmaster923 · Post by **darksmaster923** » Wed Mar 28, 2007 4:54 am

have you lowered the wall thickness? cuz if the wall thickness is bigger than the wall it crashes

zany_001 · Post by **zany_001** » Wed Mar 28, 2007 5:54 am

well if the wall thickness is 16,and i put the two z sizes to 32,then it crashes

zany_001 · Post by **zany_001** » Wed Mar 28, 2007 5:54 am

well if the wall thickness is 16,and i put the two z sizes to 32,then it crashes

but it only happens from 32 down,not 33

Juutis · Post by **Juutis** » Wed Mar 28, 2007 9:55 am

You see, if your wall thickness is bigger or equal to half of the box size, there is nothing inside and so it crashes. This only happens with hollow boxes. Just tick 'solid' and you can make even 1x1x1 boxes.

zany_001 · Post by **zany_001** » Wed Mar 28, 2007 10:05 am

thanx,that worked,

ha, i no this is an old post, but i realized wat you mean. The wall size is for TWO walls per box, so they get too big like you said. I am enlightened, probably becos i am 14 naow.OH YEAH!!