Page 1 of 1
RFeditPro Cutting levels
Posted: Sun Apr 22, 2007 4:10 am
by AeKarma
I've only been experimenting with this engine for all of today on the same level.
The level was always working fine in preview and now when I go into preview about half of the level is cut off. However it remains fine in the actual edit program.
Anyone know the cause of this?
Posted: Sun Apr 22, 2007 6:53 am
by darksmaster923
can u still go through it? the part thats cut off?
Posted: Sun Apr 22, 2007 9:40 am
by Juutis
Could you post a screenshot or something? I have never run into this kind of problem, so it's kinda hard to find out what's wrong without any extra info. The only cause I can think of right now is the farclip plane. It is a plane beyond which nothing is rendered. The field 'UseFarClipPlane' in the EnvironmentSetup properties controls the farclip plane.
Posted: Sun Apr 22, 2007 9:41 am
by Jay
Did you hide groups? If you did, unhide them all again before compiling. Sometimes this can confuse the compiler.
Posted: Sun Apr 22, 2007 8:22 pm
by AeKarma
Sorry guys I would post some screens but I scrapped it before updating the thread last night. Since it was my first time trying and it was a learning experience more than anything