Reality Factory

Always used Gimp for my graphics and have been pulling my hair out for 3 days as none of my textures would convert into .act from milkshape. I was using AStudio like the manual says, the bmp's were showing up in AViewer under material but not displaying, but proj file was showing Material 0.

Well anyway came across a forum entry from Bernie telling someone else to use "Equity" and not "AStudio" and lo and behold it wouldn't recognise the bmp either. Loaded the bmp into windows paint saved it and now everything working.

Just thought I should post this in case other newbies are having similar problems.

The problem may be from milkshape not exporting correctly. Use Equity, then replace the materials.

http://www.mediafire.com/i/?kmtnndt3mnj

A simple way is to save as .jpg instead of bmp. Milkshape takes .jpg files and so does Equity and equity also takes .ms3d files so you don't have export from Milkshape at all. Bmp files are very big and wasteful so really you should never use them for making actors. jpg or png are much better formats (Equity actually converts these files to bmp in the actor but that is because the engine only reads bmp but that's another story) as they take up less space on your hard drive. Astudio has been replaced by Equity now and does so much more, you can even use transparent textures in actors directly either by 32 bit .tga files or easier by .png or .dds files.

Bernie -Thanks for the info about graphics formats.